@1tny+1fJGh2Vm - -
I'm 55. Started on this stuff in 1989. Long live Cisco AGS+, Token Ring, Baynan Vines, Novell
https://hackaday.com/2021/09/13/cisco-router-repair-revives-piece-of-internet-history/
https://storage.microsemi.com/en-us/support/_eol/ethernet/em-595/install_sw/dos_odi.htm?nc=/en-us/support/_eol/ethernet/em-595/install_sw/dos_odi.htm
To Install and Configure the DOS ODI Driver
If you are using the VLM DOS Requester, you can run the automated Novell NetWare Client Install that comes with Novell NetWare:
-
Run INSTALL from your Novell install diskette labeled WSDOS_1
-
At STEP 4 during the install process, remove the WSDOS_1 diskette and insert your Adaptec diskette, specifying \DOSODI as the directory location for your adapter driver.
Otherwise, to install the DOS ODI driver manually, follow the instructions below.
-
Boot your system under MS-DOS version 3.1 or later.
-
Insert the Adaptec setup diskette into drive A:.
-
Copy the \DOSODI directory on the Adaptec setup diskette into your workstation's Novell NetWare directory (usually called \NWCLIENT)
-
Using a text editor, edit your AUTOEXEC.BAT file so that the driver is loaded between Novell NetWare's Link Support Layer and the network protocol, as in this example:
LSL.COM
EMPCI.COM
IPXODI.COM
VLM.EXE
-
Save and exit the AUTOEXEC.BAT file.
-
In the NWCLIENT (or your workstation's Novell NetWare directory) create a file named "NET.CFG". The following examples should offer some guidance:
Example NET.CFG Sections
Novell NetWare 3.11 Example:
Link Driver EMPCI
Frame Ethernet_802.3
Protocol IPX E0 Ethernet_802.3
Protocol IPX
Bind #1; binds IPX to first frame type listed in
"Link Driver EMPCI" section
Novell NetWare 3.12, Novell NetWare 4.x Example:
Link Driver EMPCI
Frame Ethernet_802.2
Protocol IPX 0 Ethernet_802.2