Has anyone used the new Unit Integrity for OOS?

I finally found the information on SHC Connect after noticing the OOS icon was removed from snc yesterday. Thanks to information from another thread.

(I do not get emails at sears)

My store management knew nothing about this but I noticed the job side was dated 10/4/18

I printed the job aide but did not have time today to read or get familiar with it or even try it out.

I think I am the only one in our store that does the OOS so I am just wondering what the whole point of this change is.

Anyone out there currently using the Unit Integrity?

Any tips you could give would be greatly appreciated

Is it more complicated to use?

Comment! It's anonymous!

3 replies (most recent on top)

That's my understanding. I'm assuming based on piece or dollar value of count change.

@viz thank you for the information

So this new process has to be approved by MOD before it’s transmitted ?

You dont need to create a pull list. Scan an item, submitt what you need to fill your floor. If its in a location, count will be added to fill floor. It will also allow you to change/zero counts. Once you submit count change-will be sent to MOD device for approval.

Thats the just of what we were told by SGM a couple weeks ago. Haven't tried it yet.

Thread regarding Sears layoffs

Has anyone used the new Unit Integrity for OOS?

3 replies (most recent on top)

Post a reply